CB22 Ceiling Battens

BattenMan CB22 metal batten is a cold rolled hat shaped section manufactured from .50g G550 Z275 galvanized Steel. It provides the builder/specifier with a stable accurate and lightweight steel ceiling or wall framing system which is ideal for the application of plasterboard.

The CB22 steel battens are versatile and easy to use, providing strength, lightness and rigidity with low cost. The 22mm deep profile can be used as a ceiling batten for internal fixing of ceiling and wall lining particularly when space is an issue.

The CB 22 batten can be direct fixed by nail or screw through each batten flange or batten hangers may be used to provide additional adjustment to level a ceiling. Lowering or suspending a ceiling can be carried out using the CB22 batten in conjunction with our ceiling suspension system.  

BattenMan Ceiling Battens comply with the requirements as laid down by the New Zealand Standard 4203: Table 3.4.1 for non-habitable roof spaces on domestic dwellings provided they are fitted in accordance with the manufacturers recommendations.

Each house is measured individually, Eliminating costly onsite waste. Trained installers ensure battens are fixed in accordance with the manufacturers recommendations.

Download the CB22 Ceiling Batten Specification Sheet

CB35 Ceiling Battens

BattenMan CB35 ceiling battens are manufactured from .50g G550 Z275 galvanized Steel coil cut to the required length. BattenMan CB35 ceiling battens have been produced to support Plaster Board and Fibrous Plaster Board onto ceiling joists and truss bottom chords. BattenMan Ceiling Battens comply with the requirements as laid down by the New Zealand Standard 4203: Table 3.4.1 for non-habitable roof spaces on domestic dwellings provided they are fitted in accordance with the manufacturers recommendations. BattenMan CB35 ceiling battens should be fixed at no greater than 1200mm spacing to the joists or bottom of the Truss Chord using 50mm galvanised ring shank nails.

BattenMan BH35 ceiling batten hangars may be used in place of direct fixing. BattenMan CB35 ceiling battens spacings may be at 450mm centers when using 1 O mm Plasterboard using Gypfast adhesive and 25x6 screws

Each house is measured individually, Eliminating costly onsite waste. Trained installers ensure battens are fixed in accordance with the manufacturers recommendations.

Download the CB35 Ceiling Batten Specification Sheet

RB40 Top Hat Roof Battens

BattenMan RB-40 roof Purlins are a direct replacement for timber purlins. They are light weight, dimen-sionally stable, accurate and straight. They expand and contract at the same rate as steel roofing products in extreme temperature changes. They can be fitted to both timber and steel trusses with Type 17 univer-sal Teks. Ideally suited to Timber framed homes, Steel Framed homes, Steel framed Buildings and Car-ports.

Our 40mm Purlins are designed for use with corrugate roofs or wall claddings. With spans of 1200mm at 900mm spacings they can be used in extra high wind zones and where snow loads are present. They are available in 0.75mm gauge G550 Z275 steel. Lengths are available from stock or you can choose to have them run cut to length to reduce waste on site.

Download the RB40 Top Hat Roof Batten Specification Sheet

RB40 Top Hat Roof Batten Brochure

RB40 Top Hat Roof Batten Span Table

RB40 Top Hat Roof Batten Producer statement

Buildex Batten Zip Technical data sheet

 

Battenman

106 Birch Avenue, Judea, Tauranga

Phone: 07 579 4296
Fax: 07 579 4125
FREEPHONE: 0508 BATTEN (0508 22 88 36)

© 2017 Battenman. All Rights Reserved. Hosted By Web Intelligence